This section describes the rules for configuring the 52TOM board.
The rules for configuring the 52TOM board are as follows:
- In non-cascading board working mode, the ports on the board can be set to different port working modes.
- The OptiX OSN 8800 T32(NA) and OptiX OSN 8800 T64(NA) do not support distributed cross-connection.
- In tributary-line mode, the ODU1 service does not support centralized cross-connection.
- The 52TOM board can groom a maximum of six Any services through the backplane. In the OptiX OSN 6800A/3800A, the 52TOM board can groom Any services on the opposite board but cannot groom Any services throughout the full-mesh network. Particularly,
in the OptiX OSN 3800A, inter-board ODU1 cross-connections between the 52TOM and 52NS2 boards, if required, should be configured in such a manner that the ClientLP3.1 port on the 52TOM board is cross-connected to the ODU1LP1.3 port on the 52NS2 board,
the ClientLP5.1 port on the 52TOM board is cross-connected to the ODU1LP1.2 port on the 52NS2 board, and the rest may be deduced by analogy.
- The OptiX OSN 6800A/3800A cannot groom the ODU0 service and thus does not support the following port working mode application scenarios:
- Non-cascading ODU1_ODU0 mode (OTU1->ODU1->ODU0)
- Non-cascading ODU1_ANY_ODU0 re-encapsulation mode (OTU1->ODU1->Any->ODU0)
- The OptiX OSN 8800 T32 does not support the following port working mode application scenario:
- Non-cascading ODU1_ANY_ODU0_ODU1 re-encapsulation mode (OTU1->ODU1->Any->ODU0->ODU1)
Copyright © Huawei Technologies Co., Ltd.