Modifying a VLAN Group

You can modify the configuration of a VLAN group to meet service requirements. Modifying a VLAN group is to modify the number of VLAN members.

Prerequisites

The VLAN group must be created.

Precaution

NOTICE:

Modifying a VLAN group may cause service transient interruption.

NOTE:

Setting the parameters of a port affect the service of the board. Before setting the parameters of a port, configure State of the port as OOS at the Ethernet Interface. After setting the parameters, restore State of the port to IS.

Procedure

In the NE Explorer, select the Ethernet board and choose Configuration > Ethernet Service > Ethernet Line Service from the Function Tree.
Click the VLAN Group tab.
Select a VLAN group that you want to modify, and double-click the VLAN Group Member Count to modify the number of VLANs. Then, click Apply.
NOTE:
The modified VLAN Group Member Count is restricted as follows:
- The value of Initial VLAN is in the range of 1 to 4095. The formula is as follows: Initial VLAN = p x 2ⁿ. n is an integer from 0 to 12. p is an integer from 1 to 2^m. m + n <= 12.
- The formula of VLAN Group Member Count depends on the value of the Initial VLAN. If the value of Initial VLAN is 1, VLAN Group Member Count = 2ⁿ - 1. If the value of Initial VLAN is an integer other than 1, VLAN Group Member Count = 2ⁿ. The value of n is the same as that in the formula of the Initial VLAN.
In the confirmation dialog box, click OK. The configuration is complete.