This section considers station A as an example to describe the configuration process of the 52TOM board.
Precautions
NOTE: The OptiX OSN 6800A and OptiX OSN 3800A do not support ODU1_ODU0 mode (OTU1->ODU1->ODU0) in non-cascading mode.
NOTE: - A ClientLP port can access only one service that has a rate higher than 1.25 Gbit/s, and this service can be configured in only the first channel of the ClientLP port.
- The client-side eight pairs of optical interfaces can access services at a maximum rate of 10 Gbit/s.
NOTE: The client-side optical interfaces can be selected as required.
Procedure
- Set the Working Mode of the 52TOM board. In the NE Explorer, select a 52TOM board, and choose from the Function Tree. Set Board Working mode to Non-Cascading and then set Port Working Mode to ODU1_ODU0 mode (OTU1->ODU1->ODU0). For details, see Configuring the Working Mode of the 52TOM Board.
- In the NE Explorer, select the desired board , and choose from the Function Tree. Set the Service Mode of the client-side interface of 52TOM as OTN mode. For details, refer to Configuring the Service Mode.
NOTE:
When the 52TOM board accesses OTU1 services on the client side, you first need to set the Service Mode of the 52TOM board to OTN mode.
- In the NE Explorer, select the desired board , and choose from the Function Tree. Configure the Service Type at the WDM interface of the 52TOM as OTU1. For details, see Configuring the Service Type.
- Configure the OTU1 cross-connection between the RX/TX and ClientLP interfaces on the 52TOM board.
- Configure an OTU1 cross-connection between the 3(RX1/TX1) interface and the 201(ClientLP1/ClientLP1) interface on 52TOM board.
Parameters Value Level
OTU1
Service Type
-
Direction
Bidirectional
Source Slot
Shelf2(Subrack2)-15-52TOM
Source Optical Port
3(RX1/TX1)
Source Optical Channel (eg.1,3-6)
1
Sink Slot
Shelf2(Subrack2)-15-52TOM
Sink Optical Port
201(ClientLP1/ClentLP1)
Sink Optical Channel (eg.1,3-6)
1
NOTE: The Service Type must be the same as the Service Type at the WDM interface of the 52TOM board.
- Configure an OTU1 cross-connection between the 3(RX1/TX1) interface and the 201(ClientLP1/ClientLP1) interface on 52TOM board.
- Configure ODU0 cross-connections between the 52TOM and 52NS2 boards.