WDM Service Configuration Flow

This topic describes the configuration process of services. Before configuring the WDM services, complete the basic configurations on the NE following the network creation process.

Configuring WDM Services on NEs

Figure 1 WDM service configuration flow

Task Name	Description
Configuring the Service Type	Mandatory The services can be transmitted normally only when the type of the services at the WDM interface of the board is the same as the actual service type.
Creating Cross-Connections	Optional By creating a non-protection cross-connection, you can create the intra-board or inter-board route for a single service.
Non-cross-connect services	Optional The services at the non-cross-connect port can be available after the service type is configured correctly.
Setting Performance Monitoring Parameters of an NE	Mandatory Performance monitoring keeps a detailed record of the operation of an NE, helping the maintenance engineer to monitor and analyze the operation status of the NE.

Configuring WDM Services in Service Package Mode

Figure 2 WDM service configuration flow in service package mode

NOTE:

For the 52TOM board, before configuring the service package as Tributary line 7*STM-1/OC3->OTU1 or Tributary line 7*FE->ODU0, select the unit port or channel. Click State > OOS to set the Primary, Secondary State.