OAM Parameter

In this user interface, you can configure Ethernet port OAM parameters and perform port OAM check.

Navigation Path

In the NE Explorer, select a board and choose Configuration > Ethernet Maintenance > Ethernet Port OAM from the Function Tree. Click the OAM parameter tab.

Buttons

Button		Description
OAM	Remote Side Loopback Enabled	Sets to enable the OAM remote loopback.
OAM	Remote Side Loopback Disabled	Sets to disable the OAM remote loopback.

Parameters

Field	Value	Description
PORT	For example: PORT1	Displays the port name.
Enable OAM Protocol	Disabled, Enabled Default: Disabled	After the OAM protocol is enabled, the current Ethernet port starts to use the preset mode to create the OAM connection with the opposite end.
OAM Working Mode	Active, Passive Default: Active	Sets the OAM working mode at the port.
Remote Alarm Support for Link Event	Enabled, Disabled Default: Enabled	Sets whether the local link event can be notified to the opposite end.
Remote Side Loopback Response	Disabled, Enabled Default: Disabled	If the Remote Side Loopback Response is enabled, this port responds to the loopback request from the opposite end.
Max. OAM Packet Length (byte)	For example: 1000	Displays the maximum OAM packet length.
Loopback Status	Non-Loopback, Initiate Loopback at Local, Respond Loopback of Remote	Displays the loopback status of the port.