Basic Attributes (Internal Port)

In this user interface, you can query or set basic attributes of an internal port, including port and QinQ type area.

Navigation Path

In the NE Explorer, click the board and select Configuration > Ethernet Interface Management > Ethernet Interface. Click the Internal Port and then click Basic Attributes tab.

Buttons

Button		Description
State	IS	Sets the state of the port to be in service.
State	OOS	Sets the state of the port to be out of service.
Maintenance	Remove	Changes the service state of the specified port to Out of Service - Maintenance (OOS-MA, MT). After the remove action, there is no alarm generated for the corresponding facility and existing alarms must be cleared. Any circumstances are reported as not required (NR) and performance message (PM) continues to be collected and is marked invalid. This is done before performing loopback.
Maintenance	Restore	Instructs an NE to restore service of the port on the card. The card will change the port state from maintenance to the original state. All existing alarms must be reported.

Parameters

Field	Value	Description
Port	VCTRUNKn, RPRn	VCTRUNK and RPR are the ports, and n indicates the port number.
QinQ Type Area	0x0600 to 0xFFFF	Displays in hexadecimals.
Primary, Secondary State	For example: IS-NR	Displays the state of the port.
Signal Validation Timer	Format:00-03	Signal validation timer in minutes. It is valid only when Auto In-Service feature is supported. It is a string, and the format is HH-MM.