You can configure EPLAN services on a per-NE basis by following
the instructions below.
EPLAN Service Configuration Process
This section describes the process for EPLAN service configuration process that consists of deploying a network, configure source NE, configure sink NE, configure pass-through NE and verify service.
Creating EPLAN Services
Based on the Ethernet data Layer 2 switch function, EPLAN services allow the accessed data to be transported to its destination media access control (MAC) address. This section describes the method to set the EPLAN service.
Creating VLAN Unicast
If a Layer 2 switching network is configured with VLAN unicast, the packets whose sink address is a specified MAC address can be statically forwarded through a specified port in a specified VLAN.
Verifying Ethernet Services
After configuring Ethernet services, you need to verify whether the service communication is normal.