Interface Management

This section describes the parameters related to the interface management.

• PDH Interface
  In a PSN network, the PDH interfaces can be used to carry TDM signals, IMA signals, or tunnels, depending on different settings of the interface attributes. The attributes of a PDH interface include the basic attributes, Layer 2 attributes, Layer 3 attributes and advanced attributes.
• SDH Interface
  
• Ethernet Interface
  The attributes of the Ethernet interface include the Basic Attributes, Layer 2 attributes, Layer 3 attributes, advanced attributes and flow control.
• Microwave Interface
  This section describes how to configure the IF 1+1 protection of the IF board, the IF/ODU information of the microwave link, microwave interface attributes, and ODU interface parameters.
• Serial Interface
  
• MP Group Management
  MP is a technology used to bind multiple PPP links to increase the bandwidth. MP is applied to the interface that supports PPP. MP supports fragmented packets. The fragmented packets are transmitted on multiple PPP links in the MP group to the same destination.
• Ethernet Virtual Interface
  
• Link Aggregation Group Management
  In this interface, you can query and set parameters of the link aggregation group (LAG).
• CPRI Interface
  In this interface, you can view or set CPRI port loopback status of NEs for locating device faults.
• ATM IMA Management
  When the equipment accesses IMA services, configure an ATM IMA group at the access node.
• NMS Interface
  
• LookBack Interface(RTN)
  
• PPP Running Status
  In this user interface, you can query the PPP running status of an interface.