Setting Test Parameters for a Line

Test parameters for lines determine test indicators such as the size of test scope, size of dead zone, and distinguishability of events. Before performing out-of-service tests on a line, set test parameters for the line based on test requirements. The test parameters include pulse width, sampling attempts, sampling frequency, and detection optical power.

Prerequisites

The submarine cable line is created.
This function is applicable to manual tests and baseline collection tests.

Procedure

In the NE Explorer, select an NE and choose Configuration > Submarine Cable Line Monitoring from the Function Tree.
Select a line, click Out-of-Service Mode, and choose Test Parameter Management.
In the Test Parameter Management dialog box, click Query to query the values of the test parameters.
Figure 1 SLM 1630 V100R001

Figure 2 SLM 1630 V100R002

NOTE:
After Sampling Times is set, Testing Time can be set accordingly. You can also set Testing Time to define the test duration. Sampling Times is then changed according to Testing Time.
Set the parameters based on site requirements, and click Set. The Test Parameter Management dialog box is closed.
Repeat 2 and 3 to check whether the line test parameters are successfully set.