In this user interface, you can set parameters for a ping test, and start or stop a ping test.
In the NE Explorer, select an Ethernet board and choose from the Function Tree. Click .
Button |
Description |
|---|---|
Start Ping |
Starts a ping test. |
Stop Ping |
Stops a ping test. |
Field |
Value |
Description |
|---|---|---|
Send Mode |
Burst Mode, Continue Mode |
Specifies a mode in which ping test packets are sent. |
Frame Length |
64-1522, in step length of
1 Default: 64 |
The parameter specifies the length of the Ping packets if the Ping operation is initiated at a maintenance endpoint. |
| Timeout | 3-60, in step length of 1 Default: 5 |
The Timeout (Ping Test) parameter specifies the waiting period in which no response message is received from the opposite end after a MEP initiates the Ping test. In this case, the maintenance point regards that the Ping test fails. This waiting period is called the Ping timeout time. |
Ping Attempts |
1 to 1000 times |
The number of attempts to send ping test packets if you set Send Mode to Burst Mode. If you set Send Mode to Continue Mode, this parameter cannot be edited. |
Destination IP Address |
For example, 129.9.0.123 |
The destination IP address of a ping test packet. |
Local IP Address |
For example, 129.9.0.123 |
The local IP address of a ping test packet. |
Detail |
- |
The information returned after you perform a ping test. |